English

Files Available for Download:

Rhino 4.0 SR4b (59Mb)
Matrix 6.0 SR2 Update (267Mb)
Matrix 6.0 SR2 Manual - (39Mb) *NOTE* - This is already included in the SR2 Update


Instructions for Installing the Rhino SR4b Update:

1. *NOTE* - Make sure Rhino and Matrix are both closed before running this patch.
   
   
2. Click on the Rhino 4 SR4b link then click "Save".
   
   



3. Save the file to your Desktop.
   
   
   
   
4. Double click the rh40sr_en_20080807 file you just downloaded, follow the prompts to install the update, then click Finish >.
   
   
   
   
   

1. *NOTE* - Make sure Rhino and Matrix are both closed before running this patch.
   
   
2. Click on the Matrix 6.0 SR2 Update Link then click "Save".
   
   
   
   
3. Save the file to your Desktop.
   
   
   
   
4. Double click the Matrix60Update_2009-01-02_498.exe file you just downloaded, follow the prompts to install the update, then click Finish >.
   
   
   
   
5. Click OK to reboot if prompted.
   
   
   
   
   
6. *NOTE* - If you've already ran the Matrix Key Programmer and have programmed your key for an earlier version of Matrix, you are done! However, if you haven't yet programmed your key, please continue to step 7.
   


7. Run the Matrix Key Programmer with an internet connection active, go to your Start Menu > All Programs > Matrix 6.0 > Matrix Key Programmer
   
   
   
   
8. Enter your name and company name and click the green arrow to program your key.
   
   



9. You should receive a message "Key Programmed", click OK.
   
   
   

1. Right Click on the Matrix 6.0 SR2 Manual Link and select “Save Target As...”.


2. Save the file (or, first transfer to Matrix computer if necessary) in C: Program Files > Matrix60 > Docs and choose “yes” to overwrite the current file (Matrix60Manual.pdf).

1. On another computer with an Internet connection, click on the Matrix 6.0 SR2 Update link and select “Save”. Download this file and save it to your desktop and trasnsfer a jump drive or other means to be placed on your Matrix computer.
   
   
2. On your Matrix Computer, double-click this file and select “Run”.
   
   
3. On another computer with an internet connection, (any computer with an Internet connection can be used) click on the link to the “Matrix Key Programmer” and choose “Run” to run this program. Insert one Matrix Key at a time into a USB port on this computer and follow the directions above (Steps 7 and 8) to program the key. *NOTE* - There are some cases where the Matrix Key Programmer will not run on non-matrix machines. In these cases, please download and run the Transfer Matrix Key Programmer instead.